Fellow OTMers!
Hope yall doing great!
I came across requirement where I need to plan TL shipment at different cube limit based on type of orders mixed during bulk planning and number of stops shipment built by bulk plan.
Let me explain:
Order Refnums = A, B, C
Scenario 1: if Shipment only have Orders with Refnum A and total number of stops are 4 or less; than plan TL Shipment with 3000 Cube Limit
Scenario 2: if Shipment only have Orders with Refnum A and total number of stops are 5 or more; than plan TL Shipment with 2800 Cube Limit
Scenario 3: If Shipment have orders with Refnum A & B or C and total number of stops are 4 or less; than plan TL Shipment with 2700 Cube Limit
Scenario 4: If Shipment have orders with Refnum A & B or C and total number of stops are 5 or more; than plan TL Shipment with 2500 Cube Limit
We dont know until Bulk Plan how order mix going to be, so bulk plan shipment building is decision point. Can this be achieved by configuration within OTM 6.3 or not?
Any insight or approach would be much appreciated. Thank you for taking time to read thru scenarios!
Happy OTMing!
Hope yall doing great!
I came across requirement where I need to plan TL shipment at different cube limit based on type of orders mixed during bulk planning and number of stops shipment built by bulk plan.
Let me explain:
Order Refnums = A, B, C
Scenario 1: if Shipment only have Orders with Refnum A and total number of stops are 4 or less; than plan TL Shipment with 3000 Cube Limit
Scenario 2: if Shipment only have Orders with Refnum A and total number of stops are 5 or more; than plan TL Shipment with 2800 Cube Limit
Scenario 3: If Shipment have orders with Refnum A & B or C and total number of stops are 4 or less; than plan TL Shipment with 2700 Cube Limit
Scenario 4: If Shipment have orders with Refnum A & B or C and total number of stops are 5 or more; than plan TL Shipment with 2500 Cube Limit
We dont know until Bulk Plan how order mix going to be, so bulk plan shipment building is decision point. Can this be achieved by configuration within OTM 6.3 or not?
Any insight or approach would be much appreciated. Thank you for taking time to read thru scenarios!
Happy OTMing!